Monitor Scantool Data
1.

Install Scantool and select engine part.

2.

With raise vehicle on lift , start and run engine in gear.

3.

Let vehicle idle and monitor the "VEHICLE SPEED" parameter on the Scantool data list.

4.

Does Scantool indicate near the specified value?

1)

[Specification] 10km/h or less(6mph or less)

YES

a.

Fault is intermittent caused by poor contact in the sensor’s and/or ECM’s connector.

b.

Fault was repaired and ECM memory was not cleared.

c.

If the problem works out, Go to "Verification of Vehicle Repair" procedure.

NO

a.

Go to "Inspection & Repair" procedure.

Яндекс.Метрика