Remove the battery terminal.

Remove the battery tray.

Remove the air cleaner.

A.

Upper

B.

Lower

Remove the back-up lamp switch.

After removing the CKP sensor, O2 sensor and oil pressure switch wiring bracket, separate the connectors.

Remove the speedometer driven gear connector.

Remove the clutch release cylinder mounting bolt.

Remove the cotter pin of the shift cable (transaxle side).

Remove the cotter pin of the select cable (transaxle side).

Remove the clip of the shift cable (transaxle side).

Remove the clip of the select cable (transaxle side).

Separate the steering column shaft joint.

Separate the power steering oil pump hose.

Separate the hose after removing the clip of the power steering return hose.

Remove the upper connecting transaxle bolt.

Separate the start motor.

Install the engine support fixture.

After removing the tire, remove the caliper.

Separate the tie rod end.

Remove the wheel speed sensor and the knuckle mounting bolt.

Drain the oil.

Remove the transaxle mounting bracket.

A.

Insulator bolt

B.

Body side mounting bolt (Upper)

C.

Body side mounting bolt (Side)

D.

Transaxle side mounting bolt.

Remove the front roll stopper.

A.

Insulator bolt

B.

Stopper bolt (Upper)

C.

Stopper bolt (Lower)

Remove the rear roll stopper.

A.

Insulator bolt

B.

Stopper bolt

Remove the drive shaft.

Remove the muffler.

Remove the sub frame mounting bolt.

Install the transaxle jack.

Remove the transaxle lower mounting bolt to the engine.

Remove the transaxle assembly.

Installation is the reverse of removal.