1.
Using the spring compressor (09546-26000), compress the coil spring completely.
Using the spring compressor (09546-26000), compress the coil spring completely.
Do not use an impact gun.
Follow coil spring installation chart.
Install the spring lower pad so that the protrusions fit in the holes of the spring lower seat.
Position the upper and lower ends of the coil spring in the upper spring pad and lower spring seat groove.
Install the spring seat assembly on the piston rod.
Align the D-shaped hole in the spring seat assembly with the protrusion on the piston rod.
Place the bracket so that the holes on the spring upper seat align with those on the spring lower seat in a straight line.
Tighten a new self-locking nut temporarily.
Remove the special tool (09546-26000).
While holding the piston rod, tighten the new self-locking nut to the specified torque.
Tightening torque Piston rod to bracket nut: 60-70 Nm (600-700 kg·cm, 44-52 lb·ft) |
Do not mar up the piston rod with the tool.
