1.
Remove the T.J. boot bands and pull the T.J. boot from the T.J. case.
note
Be careful not to damage the boot.
Do not disassemble the B.J. assembly.
Special grease is used on the driveshaft joint. Do not substitute with another type of grease.
The boot band should always be replaced with a new one.
Remove the T.J. boot bands and pull the T.J. boot from the T.J. case.
Be careful not to damage the boot.
Remove the snap ring and spider assembly from the driveshaft.
Clean the spider assembly.
Remove the B.J. boot bands and pull out the T.J. boot and B.J. boot.
If the boot is to be reused, wrap tape around the drive shaft splines to protect the boot.
