4.
After fitting the backing plate to the rear housing, press in the hub onto the rear housing using the special tool.
note
●
Do not press the outer race of the wheel bearing because this can cause damage to the bearing assembly.
Apply a thin coat of multi-purpose grease to the contact surface of the rear housing and bearing.
Using the special tool (09216-22100, 09532-32000) press in the bearing to the spindle.
Press-in load [kg(f), Ib(f)] : 4500-5000 (9921-11023) |
Do not press the outer race of the bearing because that can cause damage to the bearing assembly.
When installing a bearing assembly, always use a new one.
Install the snap ring.
After fitting the backing plate to the rear housing, press in the hub onto the rear housing using the special tool.
Do not press the outer race of the wheel bearing because this can cause damage to the bearing assembly.
Rotate the hub several times to seat the bearing.
Measure the wheel bearing starting torque.
Measure the end play of the hub by installing a dial gauge and check that it is within specifications.
Hub end play : 0.008 mm (0.0003 in.) or less |
Remove the dial gauge and install the rear axle assembly to the trailing arm.
