1.
Apply the grease to the rubber coupling centering device. See [Cf.] p.DS-4, LUBRICANTS.
Apply the grease to the rubber coupling centering device. See [Cf.] p.DS-4, LUBRICANTS.
Insert the rubber coupling centering device to the differential drive pinion slightly.
Align the propeller shaft for reassembly. Support the center bearing assembly.
Temporarily install the center bearing mounting bracket.
When installing center bearing mounting bracket, make the mark 'R' face to the vehicle's rear.
Install the flange so that it faces upward as shown in the illustration.
Align the marks on the companion flange and flange yoke and the differential companion flange and rubber coupling. Install the propeller shaft.
Specified torque :
Transfer flange to flange yoke : 50~60 Nm (500~600 kgf·cm, 37~44 lb·ft)
Differential companion flange to rubber coupling : 100~120 Nm (1000~1200 kgf·cm, 73~88 lb·ft)
Tighten the center bearing mounting bracket to the specified torque.
Specified torque : 40~50 Nm (400~500 kgf·cm, 29~37 lb·ft) |
