3.
Apply the specified grease to the inner race and cage. Install the cage so that it is offset on the race as shown in the illustration.
note
Use the grease included in the repair kit.
Wrap tape around the driveshaft splines (D.O.J. side ) to prevent damage to the boots.
Apply the specified grease to the driveshaft and install the boots. See [Cf.] p.DS-4, LUBRICANTS.
Apply the specified grease to the inner race and cage. Install the cage so that it is offset on the race as shown in the illustration.
Use the grease included in the repair kit.
Apply the specified grease to the cage and fit the balls into the cage.
Install the chamfered side as shown in the illustration, and then install the inner race on the drive shaft. Install the snap ring.
Apply the specified grease to the B.J. outer race and install the outer race onto the driveshaft. See [Cf.] p.DS-4, LUBRICANTS.
Apply the specified grease to the D.O.J. outer race and install the circlip. See [Cf.] p.DS-4, LUBRICANTS.
Tighten the D.O.J. boot bands.
Add the specified grease to the B.J. as much as was wiped out at inspection.
Install the boots.
Tighten the B.J. boot bands.
To control the air in the D.O.J. boot, keep the specified distance between the boot bands when they are tightened.
681.7mm (26.8 in.) |
