Drain the engine coolant.
Remove the engine harness after disconnecting the ground cable of the battery.
Remove the engine coolant sensor.
Apply sealant to the sensor's threads. Tighten it to the specified torque.
Recommended sealant : |
Three bond NO. 1324 or LOCTITE 262 |
Tightening torque |
The coolant sensor : |
20 - 40 Nm (200 - 400 kg.cm, 14 - 29 lb.ft) |
Connect the coolant sensor to the harness.
Connect the ground cable of battery.
Refill radiator with the coolant.
Do not apply oil or grease to the engine coolant pipe O-ring.
Keep the engine coolant pipe connections free of sand, dust, etc.
Insert the engine coolant pipe into the end of the engine coolant pump inlet.
Whenever installing the engine coolant inlet pipe, always replace the O-ring with a new one.
