1.
Apply engine oil to the gear and align the two timing marks.
Apply engine oil to the gear and align the two timing marks.
Apply Locitite272 to the drive gear and intermediate gear bolt.
Using the special tool, the crankshaft front oil seal installer (09231-27100), install the crankshaft front oil seal into the oil pump housing.
Apply sealant to the groove of the oil pump housing as shown.
Sealant : Loctite 5900 or equivalant |
Apply sealant approximately 2.5 ± 0.5 mm (0.098 ± 0.019 in.) in thickness.
After the application of the sealant, insetall the oil pump housing with in 5 minutes.
Install a new O - ring to the oil pump housing and tighten the flange bolts temporarily.
Install the oil pump housing with a new O - ring. Tighten bolts to the specified torque.
Tightening torque |
Front case assembly : |
20 - 27 Nm (200 - 270kg.cm, 14 - 20 lb.ft) |
Install a balance shaft assembly to the cylinder block.
Apply sealant to the groove of the pan flange as shown.
Apply sealant approximately 3 ± 0.5 mm (0.12 ± 0.019 in.) in thickness.
After the application of the sealant, install the oil pan within 5 minutes.
Install the oil pan and tighten the bolts to the specified torque.
Tightening torque |
Oil pan bolt : 10 - 12 Nm (100 - 120 kg.cm, 7 - 9 lb.ft) |
Using a 24 mm deep socket, install the oil pressure switch after applying sealant to the threaded area.
Sealant : Threebond 1104 or equivalent |
Do not torque the oil pressure switch excessively.
Tightening torque |
Oil pressure switch : |
15 - 22 Nm (150 - 220 kg.cm, 11 - 16 lb.ft) |
