3.
Lower center thrust bearing is grooveless. Upper center thrust bearing is grooveed.
Install a grooved main bearing (upper bearing) on the cylinder block side.
Install a grooveless main bearing (lower bearing) on the main bearing cap side.
Lower center thrust bearing is grooveless. Upper center thrust bearing is grooveed.
Apply engine oil to journals and pins. Install the crankshaft.
Install the bedplate . (Apply loctite 5205)
Tighten the cap bolts to the specified torque.
Tightening torque |
Main bearing cap bolts : |
15 mm : |
28 - 32 Nm (280 - 320 kg.cm, 20.7 - 23.6 lb.ft) + 120° |
12 mm : |
33.7 - 37.7 Nm (337 - 377 kg.cm, 24.9 - 27.8 lb.ft) |
Cap bolts should be tightened evenly in 4 to 5 increments before they are tightened to the specified torque.
Make sure that the crankshaft turns freely and check the end play of the crankshaft.
Using a special tool (09231 - 27000). Install the oil seal in the oil seal case. A new oil seal should be used.
Install the flywheel assembly and tighten the bolts to the specified torque.
Tightening torque |
Flywheel bolt : |
70 - 80 Nm (700 - 800kg.cm, 52 - 59 lb.ft) |
Install the drive plate and tighten the bolts to the specified torque.
Tightening torque |
Drive plate : 70 - 80 Nm (700 - 800kg.cm, 52 - 59 lb.ft) |
