1.
Remove the suction pipe and the O-ring from the oil pump.
Remove the suction pipe and the O-ring from the oil pump.
Remove the rear cover with its gasket and pin.
Remove the cam ring.
Remove the rotor and vanes
Remove the front side plate.
Remove the inner and outer O-ring.
Remove the spring.
When assembling, use a new gasket and O-ring.
Remove the pulley nut and the spring washer.
Pull off the pulley and the woodruff key.
Remove the snap ring using snap ring pliers.
Remove the drive shaft and bearing using a plastic hammer.
Remove the oil seal from the oil pump body.
When assembling, use a new oil seal.
Remove the guide bracket and nut.
Remove the connector from the oil pump body, and then remove the flow control valve and flow control spring.
Remove the O-ring from the connector.
Do not disassemble the flow control valve.
Remove the oil pump switch.
Take the spring and the spool out.
Remove the O-ring from the oil pump switch.
