2081628

1.

Igintion "ON" & Engine "OFF"

2.

Monitor DTC(Diagnostic Trouble Code) and Clear DTC with scantool

3.

Wait for 10sec until Main Relay is open. Then, monitor DTC again.

4.

Is the DTC present again ?

YES

a.

Go to " W/Harness Inspection" procedure.

NO

a.

Fault is intermittent caused by poor contact in the ICM and/or ECM’s connector or was repaired and ECM memory was not cleared. Thoroughly check connectors for looseness, poor connection, bending, corrosion, contamination, deterioration, or damage. Repair or replace as necessary and then go to "Verification of Vehicle repair" procedure.