Monitor Scantool Data
1.

After connecting Scantool and Monitor the " ENGINE SPEED,INPUT SPEED SENSOR, DAMPER CLUTCH SOL DUTY and DAMPER CLUTCH SLIP " parameter on the Scantool data list.

2.

After DAMPER CLUTCH is operated , Measure data when output-speed is more than 1000RPM and DCC Solenoide DUTY is 0%

3.

Compare with under the table.

1)

In case of Normal

a.

Remove all because defect was occured formerly and then verify trouble code again.

2)

In case Difference of between RPM and Input-speed is less than 5RPM with DUTY 0%.

a.

Go to "Component Inspection" procedure.

Яндекс.Метрика