Support the trailing arm with a jack.
Open the tail-gate.
Ply the shock absorber cover on the luggage side trim.
Remove the actuator-cap.
Loosen the rear shock absorber upper mounting nut.
Loosen the rear shock absorber lower mounting bolt.
Remove the rear strut assembly.
It is not necessary to remove a rear wheel and tire in removing only a rear strut assembly.
Tighten the rear strut lower mounting bolt.
Lift up the trailing arm with a jack, inserting the strut's rod in the hole as illustrated below.
Install the actuator-cap.
Tighten the rear strut upper mounting nut.
Install the rectangrlar-shaped cover.
Shut down the tail-gate.
Remove the dust cover and rear shock absorber cup assay as a body.
Remove the rear shock absorber cup assay from the dust cover.
Remover the upper (A) bushing and the collar.
Remove the collar from the upper (A) bushing with a plier.
Remove the rubber bumper.
Hammer the rubber bumper to the strut assembly.
After assembling the collar in the upper (A) bushing, make the collar-bushing assembly purctuated by the strut's rod.
Reassemble the dust cover and the rear shock absorber cup assay.
