3.
Monitor "TPS VALUE" parameter on CURRENT DATA.
1)
Specification :
Throttle valve fully closed: approx. 0.3~0.9V.
Throttle valve fully open : approx. 4.3~4.8V
TP sensor signal should increase smoothly as throttle is opened.
Ignition "OFF"
Install Scantool then, Ignition "ON" & Engine "OFF".
Monitor "TPS VALUE" parameter on CURRENT DATA.
Specification :
Throttle valve fully closed: approx. 0.3~0.9V.
Throttle valve fully open : approx. 4.3~4.8V
TP sensor signal should increase smoothly as throttle is opened.
Is Current data displayed correctly ?
YES
▶ Fault is intermittent caused by poor contact in the sensor’s and/or PCM’s connector or was repaired and PCM memory was not cleared. Thoroughly check connectors for looseness, poor connection,bending, corrosion, contamination, deterioration, or damage. Repair or replace as necessary and go to "Verification of Vehicle Repair" procedure.
NO
▶ Go to "Component Inspection" procedure.
