Monitor Scantool Data
1.

Connect scantool to Data Link Cable (DLC)

2.

Warm engine up to normal operating temperature.

3.

Turn "OFF" electrical devices and A/C.

4.

Monitor " Rail Pressure " parameter on the scantool.

1)

Specification : 250±20bar at Idle

Monitor pressure change of Rail Pressure Sensor after Ignition on. 270 bar is detected at warm idle(Approx. 800RPM), do not forget to check Rail Pressure Regulator duty if the value is indicated at about 15~17%. This duty value rises as accelerating and load rising. Maximum Rail Pressure and Rail Pressure Regulator duty reaches to 1400bar and 95%, respectively.

Яндекс.Метрика