3.
Monitor parameters related to "Cylinder #3 Misfire Detected" on CURRENT DATA.
1)
Specification :
Engine RPM at idle : 750 ± 100rpm
Ignition Timing : BTDC 7° ± 5°
Ignition "OFF"
Connect Scantool and Engine "ON"
Monitor parameters related to "Cylinder #3 Misfire Detected" on CURRENT DATA.
Specification :
Engine RPM at idle : 750 ± 100rpm
Ignition Timing : BTDC 7° ± 5°
Are the parameters related to "Cylinder #3 Misfire Detected" displayed correctly on Current Data?
YES
▶ Fault is intermittent caused by poor contact in the sensor’s and/or PCM’s connector or was repaired and PCM memory was not cleared. Thoroughly check connectors for looseness, poor connection,bending, corrosion, contamination, deterioration, or damage. Repair or replace as necessary and go to "Verification of Vehicle Repair" procedure.
NO
▶ Go to "W/Harness Inspection " procedure
