6.
Disconnect connectors and remove the multifunction switch.
Remove the cover on both sides under the steering wheel.
Remove two bolts by using a hexagonal wrench.
Disconnect the DAB and horn connector, and remove the steering wheel lock nut.
Using the SST, remove the steering wheel.
Do not hammer on the steering wheel to remove it; doing so may damage the collapsible shaft.
Remove steering column lower shroud and upper shroud.
Disconnect connectors and remove the multifunction switch.
Remove the switch on the left side of the lower crash pad.
Remove the lower cover.
After removing all connectors, remove the steering column shaft.
Remove the bolt that couples the universal joint and the pinion. Pull out the universal joint from the gear box.
Remove the bolts mounting the dust cover.
Remove 4 bolts mounting the steering column.
Drain the power steering fluid and disconnect the return hose and pressure hose.
Remove the steering column and shaft with the universal joint and dust cover.
Remove the cover on both sides under the steering wheel.
Remove two bolts by using a hexagonal wrench.
Disconnect the DAB and horn connector, and remove the steering wheel lock nut.
Using the SST, remove the steering wheel.
Do not hammer on the steering wheel to remove it; doing so may damage the collapsible shaft.
Remove steering column lower shroud and upper shroud.
Disconnect connectors and remove the multifunction switch.
Remove the switch on the left side of the lower crash pad.
Remove the lower cover.
After removing all connectors, remove the steering column shaft.
Remove the bolt that couples the universal joint and the pinion. Pull out the universal joint from the gear box.
Remove the bolts mounting the dust cover.
Remove 4 bolts mounting the steering column.
Drain the power steering fluid and disconnect the return hose and pressure hose.
Remove the steering column and shaft with the universal joint and dust cover.
Assembly is the reverse of disassembly.
When installing the steering lock, align the hook and shaft groove with the steering column.
Before installation, apply multipurpose grease to the groove inside the bearing and contracting surfaces of the boot and cover assembly.
Connect the steering lower shaft and joint assembly.
When installing, mount the U-joint to the gear box first, then to the steering column shaft.
Install the dust cover to the column shaft assembly.
Install the steering column assembly to the column member assembly.
Install the multifunction switch and connect the connectors.
Install the lower cover and steering column upper and lower shroud.
Install the steering wheel.
When installing, do not use a hammer because the collapsible column shaft could be damaged.
