2.
Remove the rear hub unit bearing.
Remove the wheel and tire.
Remove the rear hub unit bearing.
Remover the parking brake cable.
Remove the rear brake hose and brake tube.
After supporting the bottom of the rear torsion axle beam with a jack, remove the rear shock absorber lower mounting bolt.
Remove the rear coil spring, lowering the jack slowly.
Remove the rear torsion axle beam bracket mounting bolts to the body.
Installation is the reverse of removal.
Tighten the components below to the specified torque as follows.
Items | Torque Nm (kgfcm, lbft) |
Rear hub unit bearing mounting bolt | 80~90 (800~900, 59~67) |
Rear shock absorber lower mounting | |
Rear torsion axle beam mounting bolt | 100~120 (1000~1200, 74~88) |
Rear torsion axle beam bracket | 100~120 (1000~1200, 74~88) |
Install the parking brake cable.
Bleed the brake line system (Refer to the adjustment precedure in the Brake system).
