2.
Remove the air duct (2 Bolts).
Discharge the refrigerant and coolant and disconnect the radiator upper hose.
Remove the air duct (2 Bolts).
After removing the radiator reservoir, remove the 4 radiator support bolts.
Tighten torque : 4~6Nm
Remove the cooling module connector.
Remove the cooling module (condenser).
Remove the liquid tube nut.
Remove the condenser mounting bolts (2).
Tightening torque : 8~12Nm
Remove the condenser upward by pressing the radiator backward the vehicle.
Installation is the reverse of removal.
Check condenser pin for clogging and damage. If clogged, clean it with water, and blow it with compressed air. If bent, gently stretch it using a screwdriver or pliers.
Check the condenser connection area for leakage, and repair or replace if required.
