Remove the clutch hub and pulley.

Install a shaft protection tool at the compressor opening.

Install the pulley at the compressor.

Place the puller screw end at the shaft protectors center concave and the puller projection around the rear side field coil.

Turn the puller screw using a wrench and remove the coil.

caution

Do not use air tools.

Clean the front head coil mounting portion.

Place the compressor vertically and put the coil in position of compressor front head.

Check the electric connector of clutch coil is located in position

Place the coil compression tool in the compressor nose and the center of field coil.

Place two 8 inch pullers on the compressor and compression tool. The jaws of puller should deeply hold the front mounting portion of compressor, then the screw should be located in the central position of the compression tool.

Using a wrench, tighten the screw so as to securely seat the coil on the compressor front head.

Install the clutch pulley and hub on the compressor.