Install the camshaft after lubricating the journal of the camshaft with engine oil.
Install the camshaft bearing caps. (1.3 L)
Install the ignition coil (1.1 L)
Install the rocker arm and rocker arm shaft.
Refer to the "Rocker Arms and Rocker Arm Shafts" section.
Using the Special Tools, Camshaft Oil Seal Installer (09221-21000), press and fit the camshaft oil seal. Be sure to apply engine oil to the external surface of the ouil seal.
Insert the oil seal along the camshaft front end and install by driving the installer with a hammer until the oil seal is fully seated.
Install the camshaft sprocket and tighten the bolts to the specified torque.
Tightening torque
Camshaft sprocket bolt :
80 ~ 100 Nm (800 ~ 1000 kg.cm, 59 ~ 74 lb.ft)
Align the camshaft sprocket and crankshaft sprocket timing marks. The piston in the No. 1 cylinder will then be at top dead center on the compression stroke.
Intall a gasket in the rocket cover groove.
Temporarily install the rocker cover.
Start the engine and run at idle.
Install the rocker cover and tighten the bolts to the specified torque.
Tightening torque
Rocker cover bolt : 8~10Nm (80~100 kg.cm, 6~7 lb.ft)
Install the timing belt cover.
Install the coolant pump pulley and crankshaft pulley.
