2.
Align the camshaft timing chain with intake timing chain sprocket and exhaust timing chain sprocket as shown.
Install the HLA.
Align the camshaft timing chain with intake timing chain sprocket and exhaust timing chain sprocket as shown.
Install the camshaft after lubricating the camshaft journals with engine oil.
Install the bearing caps. The markings on the caps are for intake/exhaust identification.
I: Intake camshaft
E: Exhaust camshaft
Tighten the bearing caps to the specified torque in two or three steps as shown.
Tightening torque
Bearing cap bolt :
12 ~ 14 Nm (120 ~ 140 kg.cm, 9 ~ 10 lb.ft)
Using the special tool, camshaft oil seal installer (09221 - 21000), press fit the camshaft oil seal. Be susre to apply engine oil to the oil seal lip. Insert the oil seal along the camshaft front end and install by driving the installer with a hammer until the oil seal is fully seated.
Install the camshaft sprocket bolts to the specified torque.
Tightening torque
Camshaft sprocket bolt
80 ~ 100Nm (800 ~ 1000 kg.cm, 59 ~ 74 lb.ft)
Align the camshaft sprocket and crankshaft sprocket timing marks. Place the poston in the No.1 cylinder to top dead center on the compression strokie.
Install the cylinder head cover.
Tightening torque
Cylinder head cover bolts :
8 ~ 10 Nm (80 ~ 100 kg.cm, 6 ~ 7 lb.ft)
Install the spark plug cables, ignition coil assembly and cylinder head center cover.
Install the timing belt and then tighten the timing belt tensioner pulley.
Install the timing belt cover.
Tightening torque
Timing belt cover : 8 ~ 10Nm (80 ~ 100 kg.cm, 6 ~ 7 lb.ft)
Install the coolant pump pulley and crankshaft pulley.
