Install the rocker arms and rocker arm shaft springs to the rocker arm shafts, install the rocker arm shaft to the cylinder head.
Tighten the rocker arm shaft mounting bolts to the specified torque.
Tightening torque
Rocker arm shaft mounting bolt
1.3 L : 20 ~ 27 Nm (200 ~ 270 kg.cm, 15 ~ 20 lb.ft)
1.1 L : 27 ~ 32 Nm (270 ~ 320 kg.cm, 20 ~ 24 lb.ft)
When installing the rocker arm, shaft and spring, mark the difference of left and right part.
Use the spring without distinction of intake and exhaust valve.
Must set the part that is small chamfer side between tow parts of rocker arm shaft to the timing belt.
Install the air rocker cover and tighten the bolts to the specified torque.
Tightening torque
Rockr cover bolt :
8 ~ 10 Nm (80 ~ 100 kg.cm, 6 ~ 7 lb.ft)
Sealant must be applied to top surface of cylinder head and cam cap and area of application is shown in figure.
The proper amount of sealant must be used to prevent the sealant from pushing excessive amounts.
Use sealant of specified brands or equivalant.
Sealant (Three bond No. 1212D aluminum color or equivalent) application place (4 place).
Install the timing belt cover.
Tightening torque
Timing belt cover bolt :
10 ~ 12 Nm (100 ~ 120 kg.cm, 7 ~ 9 lb.ft)
Install the breather hose, PCV hose, blow by hose and spark plug cable.
Install the air intake hose and aor duct.
