Monitor DTC Status
caution

Whenever the ignition switch is ON, or has been turned OFF for at least one minutes, be careful not to bump the Airbag unit The airbags could accidentally deploy and cause damage or injuries.

1.

Ignition "OFF", connect scantool.

2.

Ignition "ON"& Engine "OFF", select "Diagnostic Trouble Codes(DTCs)" mode.

3.

Monitor diagnostic trouble code and present of trouble code.

4.

Using a scan tool, clear the DTCs.

5.

Is DTC present problem ?

YES

a.

Go to "W/Harness Inspection" procedure.

b.

Check for an open circuit in the SRS wiring harness and system.

NO

a.

Intermittent failure, system is OK at this moment.

b.

Fault is intermittent caused by wiring problem. Repair or replace as necessary and then go to "Verification of Vehicle Repair" procedure.

Яндекс.Метрика