IG KEY : ON, Engine: ON
Lift a vehicle.
Measure voltage between SHIFT SOLENOID C04 Terminal 6 and GND with MULTIMETER or OSCILLOSCOPE
speed up and shift more than 3rd gear position in D RANGE
Verify that voltage of SHIFT SOLENOID C change 0V into 12V.
<Scantool normal data>
- Start a vehicle ,Verify terminated diagnosis of parts ,which is fixed properly
- Remove all trouble code and then check for trouble code again
- In occuring trouble , try cranking more than 2 times and then verify alarm light.
Monitoring for (pending) DTC. Is DTC P0760 set?
YES
Go to the applicable troubleshooting procedure.
NO
System OK
IG KEY : ON, Engine: ON
Lift a vehicle.
Measure voltage between SHIFT SOLENOID C04 Terminal 6 and GND with MULTIMETER or OSCILLOSCOPE
speed up and shift more than 3rd gear position in D RANGE
Verify that voltage of SHIFT SOLENOID C change 0V into 12V.
<Scantool normal data>
- Start a vehicle ,Verify terminated diagnosis of parts ,which is fixed properly
- Remove all trouble code and then check for trouble code again
- In occuring trouble , try cranking more than 2 times and then verify alarm light.
Monitoring for (pending) DTC. Is DTC P0760 set?
YES
Go to the applicable troubleshooting procedure.
NO
System OK
