Monitor Scantool Data
1.

IG KEY : ON, Engine : ON

2.

Connect Scantool,select Service Data procedure.

3.

Select Engine RPM, Input speed, DCCSV(DAMPER CLUTCH CONTROL SOLENOID VELVE) DUTY and DCC slip. Do graphic mode.

4.

Drive vehicle and measure data

5.

Compare with under the table.

caution

<Scantool normal data>

a.

In case of Normal

a.

Remove all because defect was occured formerly and then verify trouble code again.

b.

Incase Difference of between RPM and Input-speed is more than 100RPM with DUTY 30%

a.

Go to Controller Inspection procedure.

Яндекс.Метрика