5.
Compare with under the table.
caution
<Scantool normal data>
- Start a vehicle ,Verify terminated diagnosis of parts ,which is fixed properly.
- Remove all displayed DTC and then check for trouble code again
IG KEY : ON , Engine: ON
Connect Scantool,select Service Data procedure.
Select Engine RPM, Input speed, DCCSV(DAMPER CLUTCH CONTROL SOLENOID VELVE) DUTY and DCC slip. Do graphic mode.
Drive vehicle and measure data
Compare with under the table.
<Scantool normal data>
- Start a vehicle ,Verify terminated diagnosis of parts ,which is fixed properly.
- Remove all displayed DTC and then check for trouble code again
Monitoring for (pending) DTC. Is DTC P0741 set?
YES
Go to the applicable troubleshooting procedure.
NO
System OK
