5.
Compare with under Standard Data.
caution
<Scantool normal data>
- Start a vehicle ,Verify terminated diagnosis of parts ,which is fixed properly
- Remove all trouble code and then check for trouble code again
IG KEY : ON , Engine : ON
Connect Scantool,select Service Data procedure.
Lift a vehicle. Drive vehicle for more than 3000rpm and Output shaft speed 1000rpm.
Verify that INPUT DATA is measured.
Compare with under Standard Data.
<Scantool normal data>
- Start a vehicle ,Verify terminated diagnosis of parts ,which is fixed properly
- Remove all trouble code and then check for trouble code again
Monitoring for (pending) DTC. Is DTC P0717 set?
YES
Go to the applicable troubleshooting procedure.
NO
System OK
