1.
Remove the battery terminal and the battery.
Remove the battery terminal and the battery.
Remove the battery tray. (Bolt : 5EA)
Remove the battery tray bracket. (Bolt : 5EA)
Removal of air cleaner
Upper
Lower (Bolt : 3EA)
One bolt among the three bolts is installed in the lower position of the cowl top cover.
Remove the air cleaner bracket.
Remove the back-up lamp switch.
Remove the clutch release mounting bolts.
Remove the cotter pin of the shift cable.
Remove the cotter pin of the selector cable.
Remove the clip of the shift cable.
Remove the clip of the selector cable.
Remove the speedometer driven gear connector.
Remove the tire.
Remove the starter motor upward the transaxle.
Remove the bolt for the upper connection of the engine and the transaxle.
Remove the caliper after lifting up the vehicle.
Separate the tie rod end from the pin and nut.
Remove the oil drain plug and drain the oil.
Remove the wheel speed sensor and the knuckle mounting bolt.
Remove the drive shaft and the hub nut.
Install the special tools (09200-38001, 09200-1C000), the engine support fixture and the adapter, on the engine assembly.
When using the special tool, be careful that the hook holder of the special tool doesn't wear the cowl top cover.
Remove the transaxle mounting bracket.
Body mounting side (Left side)
Insulator bolt
Remove the transaxle rear mounting bracket (Bolt : 2EA) after lifting up the vehicle.
Remove the bell housing cover. (Bolt : 5EA)
Install the jack for supporting transaxle.
Remove the lower mounting bolts of the transaxle.
Remove the transaxle.
