Thoughly clean each part before assembly.
Apply engine oil to sliding and rotating parts.
After installing the spring seat, fit the stem seal into the valve guide.
To install, fit the seal in by lightly tapping the Special Tool, Valve Stem Oil Seal Installer.
The seal is installed in the specified position by means of the special tool. Incorrect installation of the seal will adversely affect the lip I.D. and eccentricity, resulting in oil leaking down the valve guides. Therefore, when installing, be careful not to twist the seal. Do not reuse old stem seals.
Apply engine oil to each valve. Insert the valves into the valve guides. Avoid using force when inserting the valve into the seal. After insertion, check to see if the valve moves smoothly.
Install springs and spring retainers. Valve springs should be installed with the enamel coated side toward the valve spring retainer.
Valve springs should be installed with the enamel coated side toward the valve spring retainer.
Using special tool, Valve Spring Remover and Installer, compress the spring. Be careful that the valve stem seal is not distorted by the bottom of the retainer. Then install the retainer locks. After installation of the valves, make certain that the retainer locks are properly installed.
Install the cylinder head. Refer to "Cylinder Head"
