1.
Install the brake booster and tighten mounting nut.
Tightening torque Nm (kgf·cm, lb·ft)
Brake booster mounting nut : 8~12 (80~120, 6~9)
Install the brake booster and tighten mounting nut.
Tightening torque Nm (kgf·cm, lb·ft)
Brake booster mounting nut : 8~12 (80~120, 6~9)
Apply grease to the contact points of the brake pedal and the push rod.
Connect the brake pedal and the clevis with a clevis pin and install the split pin to the clevis pin.
After installing the master cylinder, install the brake tube to the master cylinder.
Connect the vacuum hose to the brake booster.
Make sure that there are no bend, twist, or leaks in the vacuum hose.
When installing the vacuum hose to the vacuum pipe, the vacuum pipe should be inserted to the depth of 25~27mm (0.98~1.06 in.) as shown in the illustration.
Fill the brake reservoir with brake fluid, and bleed the system. (Refer to "Air bleeding" in adjustment procedure)
Check for brake fluid leaks.
Inspect and adjust the brake pedal. (Refer to "Brake pedal height adjustment" in adjustment procedure)
After installation, apply grease to the contact points of the clevis and brake pedal sufficiently.
