1.
Remove oil filler plug(A).
Inspect each component for evidence of leakage.
Check the gear oil level by removing the filler plug.
If the oil is contaminated, it is necessary to replace it with new oil.
Remove oil filler plug(A).
Check level with finger.
Oil level must be up to fill the hole, add oil until it runs over.
Install filler plug.
Filler plug tightening torque :
60-80 Nm (600-800 kgf.cm, 43-58 lb-ft)
With the vehicle parked on a level surface, remove the drain plug.
Drain the transaxle oil.
Install the drain plug with new washer.
Drain plug tightening torque:
60-80 Nm (600-800 kgf.cm, 43-58 lb-ft)
Add new oil through the fille plug hole and fill it just below the plug opening.
Standard oil SAE 75W/85, API GL-4
Oil capacity: 2.0 liter (2.1 US qt, 1.76 lmp qt)
Disconnect the common connector(A).
Check the continuity between no. 6 and 7 terminals when the shift lever is in reverse. If there isn't continuity, go to next step.
Disconnect the backup lamp switch(A).
Check the continuity between no. 1 and 2 terminals of backup lamp switch.
When the shift lever is in reverse, there should be contunuity.
If necessary, repair or replace the backup lamp switch.
Disconnect the common connector (A).
Check the continuity between no. 2 and 5 terminals when the shift lever is in neutral position. If there isn't continuity, go to next step.
Disconnect the neutral switch connector (A).
Check the continuity between no. 1 and 2 terminals of neutral switch, when the shift lever is in neutral position, there should be continuity.
If necessary, repair or replace the neutral switch.
Disconnect the drive shaft from the transaxle. (see "DS" group)
Using a flat-tip screwdriver, remove the oil seal.
Using the special tool(09452-21200), tap the drive shaft oil seal into the transaxle.
