Support the specified point of the vehicle with a lift.

Drain the power steering fluid.

Remove the front tires (RH/LH).

After removing the split pin, disconnect the tie rod from the knuckle using a special tool (09568-31000).

Disconnect the shaft assembly from the gear box inside the passenger compartment.

Raise up the vehicle.

Loosen the power steering pressure tube mounting clamp and return tube mounting clamp mounting bolt.

Disconnect the front muffler assembly in the engine side.

Disconnect the transaxle rear mounting bracket from the crossmember.

After supporting the crossmember assembly with a transaxle jack, loosen the 4 bolts fixing the crossmember.

Disconnect the pressure tube and return tube fifting from the power steering gear box.

Lower the vehicle and disconnect the pressure hose connector from the oil pump. (When removing the pressure hose)

Disconnect the pressure hose assembly. (When removing the pressure hose)

After disconnecting the washer reservoir tank, remove the 2 clamps-fixing the return tube and hose. (When removing the return tube)

After removing the clip from the color tube, removing the return tube and hose. (When removing the return tube and hose)

Loosen the 2 mounting bolts in the front pump upper portion. (When removing the color tube)

Remove the 10mm color tube mounting clip bolt. (When removing the color tube)

Disconnect the remove the color tube from the power steering oil reservoir tank side hose. (When working on the color tube)