2.
Remove the mounting clips (4EA) from the quater fixed glass.
To remove the quarer fixed glass, first remove the following parts :
Rear seat ("See page BD-80")
Quarter inner trim ("See page BD-54")
Rear pillar trim ("See page BD-57")
Remove the mounting clips (4EA) from the quater fixed glass.
After removing the quater fixed glass molding, cut the sealant using the Special Tool.
Remove the quarter fixed glass.
Using a cutter knife or the Special Tool, scrape the old sealant smoothly to a thicknes of about 2mm (0.08in) on the bonding surface around the entire quarter fixed glass flange.
Be careful not to remove more adhesive than nesessary, and also not to damage the paintwork on the body surface with the knife. If the paintwork is damaged, repair the damage area with touch-up paint.
Clean the body flange surface of quarter fixed glass flange with a sponge dampened in isopropyl alchol.
Clean completely the contaminats such as oil and dust in the primer-applied part of body flange.
After cleaning body flange surface, pass a minute or more then, apply the body primer to body flange.
Apply the body primer to body flange surface of quarter fixed glass.
To use the body primer, shake the vessel enough.
Apply the glass primer to the glass and the glass moulding assembly.
Apply the sealanto to the entire circumference of the quarter fixed glass.
Install the glass to the body within five minutes.
Install the quarter fixed glass.
