3.
Unscrew the three mounting nuts(A).
Turn ignition switch to OFF position.
Disconnect the negative battery (-) terminal and wait for about 30 seconds.
Unscrew the three mounting nuts(A).
Disconnect the heater connector (B), water sensor connector (C) and thermo switch connector (D).
Remove air cleaner assembly (Refer to "EM" group).
Disconnect the fuel inlet hose (E) and fuel outlet hose (F).
Cover the hose connection with a shop towel to prevent splashing of fuel caused by residual pressure in the fuel line.
Remove the fuel filter assembly.
Connect the fuel inlet hose(A) and fuel outlet hose(B).
Remove air cleaner assembly (Refer to "EM" group).
Connect the heater connector(C), water sensor connector(D) and thermo switch connector(E).
Fasten the three mounting nuts(F).
Connect the negative(-) terminal.
Start the engine and check for leakage on fuel line connected to fuel filter.
General insepction.
Hose and pipe for bent, damage, clogging or corrosion. Fuel filter for cologging and damage. |
The fuel filter inspection must be completes in case of below.
Draining fuel in fuel tank and then refilling fuel. Replacing the fuel filter. Removing the main fuel hose (pipe). |
Fuel filter deflation.
Remove the air plug(I) of fuel filter. Cover the air plug with service towel, and then push the manual pump(J) until a bubble dose not flow out. Faten the air plug(I), and then push the manual pump again until pushing the manual pump gets to be difficult. |
Pulling out water from fuel filter.
Unfasten the drain plug(K). Push the manual pump(J) until water dose not flow out. Fasten the drain plug(K). |
