4.
Install the upper and lower anchor bolts.
Tightening Torque (Seat Belt Anchor Bolt)
: 4.0 ~ 5.5 kgf.m (39.2 ~ 53.9 Nm, 28.9 ~ 39.8 lb.ft)
Disconnect the negative (-) cable from battery and wait for at least three minutes.
Remove ignition key from the vehicle.
Install the Seat Belt Pretensioner (BPT) with bolt.
Install the upper and lower anchor bolts.
Tightening Torque (Seat Belt Anchor Bolt)
: 4.0 ~ 5.5 kgf.m (39.2 ~ 53.9 Nm, 28.9 ~ 39.8 lb.ft)
Install the center pillar trim.
Install the front seat assembly.
Reconnect the negative battery cable.
After installing the Seat Belt Pretensioner (BPT), confirm proper system operation:
Turn the ignition switch ON; the SRS indicator light should blink for about six seconds and then go off.
