Remove the front door trim panel. (Refer to BD group-Front door)

Disconnect the 6P connector from the actuator.

Check actuator operation by connecting power and ground according to the table. To prevent damage to the actuator, apply battery voltage only momentarily.

Remove the rear door trim panel. (Refer to BD group-Rear door)

Disconnect the 6P connector from the actuator.

Check actuator operation by connecting power and ground according to the table. To prevent damage to the actuator, apply battery voltage only momentarily.

Remove the front door trim panel. (Refer to BD group-Front door)

Disconnect the 6P connector from the actuator.

Check for continuity between the terminals in each switch position according to the table.

Remove the rear door trim panel. (Refer to BD group-Rear door)

Disconnect the 6P connector from the actuator.

Check for continuity between the terminals in each switch position according to the table.

Remove the tailgate trim panel. (Refer to BD group-Tailgate)

Disconnect the 6P connector from the actuator.

Check actuator operation by connecting power and ground according to the table. To prevent damage to the actuator, apply battery voltage only momentarily.

Remove the tailgate trim panel. (Refer to BD group-Tailgate)

Disconnect the 6P connector from the actuator.

Check for continuity between the terminals in each switch position according to the table.

Remove the tailgate trim panel. (Refer to BD group - Tailgate)

Remove the tailgate latch after removing 3 bolts and disconnect the 1P connector from the tailgate switch.

Check for continuity between the terminal and ground according to the table.

Remove the air duct after removing 2 bolts.

Disconnect the 1P connector from the hood switch.

Check for continuity between the terminal and ground according to the table.

Remove the driver's crash pad lower panel. (Refer to BD group-Crash pad)

Disconnect the 4P connector from the door warning switch.

Check for continuity between the terminals in each position according to the table.

Remove the horn after removing a bolt and disconnect the 2P connector from the horn.

Test the horn by connecting battery power to the terminal 1 and ground the terminal 2.

The horn should make a sound. If the horn fails to make a sound replace it.