1.
Remove the tie rod end from the tie rod.
Remove the tie rod end from the tie rod.
After mounting the tie rod end in a vise, remove the dust cover from the ball joint.
Remove the bellows band.
Remove the bellows clip.
Pull the bellows out toward the tie rod.
Check for rust on the rack when the bellows are replaced.
Unstake the tab washer which fixes the tie rod and rack with a chisel.
Remove the yoke plug locking nut.
Remove the yoke plug with a 14mm socket.
Remove the lock nut, yoke plug rack support spring, rack support yoke and bushing.
Move the rack completely toward the housing and mount the rack tooth portion in a brass plate of a vise.
At the state of step 11, loosen the tie rod ball joint, then remove the tie rod assembly from the rack.
Remove the rack from the gear housing.
Remove the rack toward the left side of the vehicle so as not to damage the bushing by the rack teeth.
