a.
Specification: Connecting the point of contact → 0 Ω , Disonnecting the point of contact → ∞ Ω
Specification: Connecting the point of contact → 0 Ω , Disonnecting the point of contact → ∞ Ω
Is resistance within specifications?
YES
Go to "2. KICK DOWN SERVO ADJUSTMENT" as below
NO
Replace "K/D SWITCH" as necessary and go to "Verification Vehicle Repair" procedure
Completely remove all dirt and other contaminating materials adhered around the kickdown adjust screw.
Loosen the lock nut.
Loosen and tighten the adjust screw(A) two times by torque of 5Nm(3.6lb·ft).
After Adjusting, Has problem been solved ?
YES
Go to "Verification Vehicle Repair" procedure.
NO
Substitute with a known-good TCM/PCM and check for proper operation. If the problem is corrected, replace PCM/TCM as necessary and go to "Verification Vehicle Repair" procedure.
