3.
Measure resistance between terminal 1 and 2 of the SMARTRA harness connector
a.
Specification : Approx. 8.6 Ω
Ignition " OFF"
Disconnect SMARTRA connector
Measure resistance between terminal 1 and 2 of the SMARTRA harness connector
Specification : Approx. 8.6 Ω
Is the measured resistance within specifications ?
YES
Go to " Check SMARTRA" as below.
NO
Check for open or short in harness between SMARTRA and Antenna coil, repair or replace as necessary. And then, go to "Verification of Vehicle Repair" procedure.
Ignition " ON" & Engine " OFF "
Perform the Neutral, Teaching, and Password teaching/ changing mode according to 2. PCM neutalization, 3.Key Teaching Procedure, 4. Password teaching/Changing in "Reference Data" described in General Information.
Be sure that PIN code is prepared before performing neutral mode.
Is Key teaching completed ?
YES
Go to "Check PCM" as below.
NO
Substitute with a known-good SMARTRA and check for proper operation. If the problem is corrected,replace SMARTRA and go to "Check PCM" as below.
In case of faulty SMARTRA, there are no special procedures required. A new SMARTRA device simply replaces the old one. (There are no transponder-related data stored in this device.)
