1.
Remove the T.J. boot bands and pull the T.J. boot from the T.J. case.
note
Be careful not to damage the boot.
Do not disassemble the B.J. assembly.
Special grease must be applied to the driveshaft joint. Do not substitute with another type of grease.
The boot band should be replaced with a new one.
Remove the T.J. boot bands and pull the T.J. boot from the T.J. case.
Be careful not to damage the boot.
Seperate the T.J. boot from the T.J. case.
Remove the snap ring and spider assembly from the driveshaft.
Clean the spider assembly.
Loosen the band after prying the band clip with a screw driver and pull out the T.J. boot and B.J. boot.
If the boot is to be reused, wrap tape around the driveshaft splines to protect the boot.
Remove the dust cover from the B.J. case with the special tool(09495-33000) or equivalent.
