2.
Replace the gasket with a new one and install the drain plug.
Tightening torque :
Drain plug : 30~35 Nm (300~350 kg·cm, 22~25 lb·ft)
Inspect the transaxle for evidence of leakage. Check the gear oil level by removing the filler plug. If the oil is contaminated, it is necessary to replace it with new oil.
Remove the oil filler plug and check the level with finger.
Oil level must be up to the filler hole. If it is below the hole, add oil until it runs out, then reinstall the plug.
Replace the oil if the transaxle gear oil is noticeably dirty, or it is not of a suitable viscosity.
With the vehicle parked on a level surface, remove the drain plug and drain the transaxle oil.
Replace the gasket with a new one and install the drain plug.
Tightening torque :
Drain plug : 30~35 Nm (300~350 kg·cm, 22~25 lb·ft)
Add new oil the through the filler plug, filling to the same level as the opening plug.
Transaxle oil total capacity :
2.15 Liters (2.27 U.s.qts., 1.89 lmp.qts.)
Tightening torque :
Filler plug : 30~35 Nm (300~350 kg·cm, 22~25 lb·ft)
Disconnect the drive shaft from the transaxle (Refer to DS GROUP).
Using a flat-tip screwdriver, remove the oil seal.
Using the special tool (09431-21200), tap the drive shaft oil seal into the transaxle.
Apply a coating of gear oil to the lip of the oil seal.
Transaxle gear oil :
HYUNDAI GENUINE PARTS MTF 75W/90
conforming to API GL-4 or higher
