Disconnect the negative (-) cable from battery and wait for at least three minutes.
Remove ignition key from the vehicle.
Place a Passenger Airbag (PAB) on the crash pad and tighten the Passenger Airbag (PAB) mounting nuts.
Tightening Torque
: 0.1 ~ 0.2 kgf.m (1.2 ~ 1.8 N.m, 0.9 ~ 1.3 lb.ft)
Install the crash pad. (Refer to BD group)
Tighten the PAB mounting bolts.
Tightening Torque
: 0.8 ~ 0.9 kgf.m (8.0 ~ 9.1 N.m, 5.9 ~ 6.7 lb.ft)
Connect the Passenger Airbag (PAB) harness connector to the SRS main harness connector.
Reinstall the bolve box. (Refer to BD group)
Reconnect the battery negative cable.
After installing the Passenger Airbag (PAB), confirm proper system operation:
Turn the ignition switch ON; the SRS indicator light should blink for about six seconds and then go off.
