2.
The brake tubes should be installed away from edges, weld beads or moving parts.
(1)
Align the brake hose connector to the bracket groove.
(2)
Install the brake hose clip.
(3)
Tighten the brake hose connecting flare nut.
Install the brake hoses so as they do not twist.
The brake tubes should be installed away from edges, weld beads or moving parts.
Align the brake hose connector to the bracket groove.
Install the brake hose clip.
Tighten the brake hose connecting flare nut.
Tighten the connections to the specified torque.
: 13-17 Nm (130-170 kgf·cm, 10-12 lb·ft)
Brake hose to front caliper :
25-30 Nm (250-300 kgf·cm, 18-22 lb·ft)
After replacing the brake hose, bleed the system. (Refer to "Air bleeding" of adjustment procedure)
