REPLACEMENT
caution

When exchanging ECMS, be sure to input injector data (7 digits) of each cylinder into a new ECM using a Hi-scan(pro).

1.

After turning ignition switch off, wait for 30sec..

2.

Remove the battery cable(-).

3.

Remove the ECM connector.

4.

Remove the ECM from the air cleaner assembly.

5.

Install a new ECM with air cleaner assembly.

6.

Fasten four mounting bolts.

7.

Using a Hi-scan(pro), input the injector data (7 digits) into a new ECM as next procedure.

caution
1.

When "WRITING FAIL" is displayed ON Hi-scan(Pro), input injector data (7digits) of each cylinder into a new ECM again as prior procedure.

2.

If the glow lamp is flashed and DTC P1586 is detected ignition switch ON, take proper steps refering to "P1586 DTC Troubleshooting procedure".

Яндекс.Метрика