1.
Install the brake disc (A) and tighten the screw (B).
Tightening torque :
4.9 ~ 5.9 N.m (0.5 ~ 0.6 kgf.m, 3.6 ~ 4.3 lb-ft)
Install the brake disc (A) and tighten the screw (B).
Tightening torque :
4.9 ~ 5.9 N.m (0.5 ~ 0.6 kgf.m, 3.6 ~ 4.3 lb-ft)
Install the rear caliper (B) and tighten the caliper mounting bolts (A).
Tightening torque :
65.0 ~ 70.0 N.m (6.5 ~ 7.5 kgf.m, 47.0 ~ 54.2 lb-ft)
Install the pads (B), the pad springs (C) from the caliper carrier (A).
Check the foreign material at the pad shims and the back of the pads.
Contaminated brake discs or pads reduce stopping ability. Keep grease off the discs and pads.
Push in the piston using the SST (09581-11000) so that the caliper will fit over the pads. Make sure that the piston boot is in position to prevent damaging it when installing the caliper.
Install the caliper body (A).
Be careful not to damage the piston pin boot.
Install the brake hose bolt (B) and the guide rod bolts (C) to the caliper assembly (A).
Refill the master cylinder reservoir to the MAX line.
Bleed the brake system.
(Refer to Brake System - "Bleeding of Brake System")
