1.
Remove 4 screws and 2 clips holding the tailgate trim panel.
Remove 4 screws and 2 clips holding the tailgate trim panel.
Remove the rear wiper arm after removing a nut.
Tightening torque
10~13 Nm (100~130 kg·cm, 7.3~9.5 lb·ft)
Remove a hexagonal nut after removing a pivot cover.
When installing cap & pad, the arrow mark should be indicated upward.
Tightening torque
10~14 Nm (100~140 kg·cm, 7.3~10.2 lb·ft)
Remove the rear wiper motor after removing 2 bolts and disconnect the wire connector.
Tightening torque
7~11 Nm (70~110 kg·cm, 5.1~8.0 lb·ft)
Installation is the reverse of removal.
