Disconnect the negative(-) battery terminal.

Remove the 3 bolts and disconnect the airbag connector and the horn connector, then remove the airbag module.

caution

Remove the horn pad only for vehicle without airbag.

Remove the steering wheel lock nut.

Remove the steering wheel with special tool (09561-11002).

caution

Do not hammer on the steering wheel to remove it. Doing so may damage the collapsible mechanism.

Remove the steering column shroud after removing 3 screws.

Remove the clock spring.

Disconnect the wire connectors and remove the multi-function switch after pressing down the indicated parts as shown in the illustration.

Remove the 2 bolts and 2 screws holding the driver's side crash pad lower panel and remove it.

Remove the 4 bolts connecting steering column shaft to universal joint and pinion.

Remove a bolt connecting universal joint to gear box.

Remove the steering column shaft assembly.

Remove the key lock assembly from the steering column shaft. (Refer to ST group)

Remove the driver's side crash pad lower panel.

Disconnect the ignition switch connector and the door warning switch connector under the steering column.

Check for continuity between the terminals.

If continuity is not as specified, replace the switch.