5.
Disconnect the SRSCM harness connector (A) from the SRSCM (B).
Disconnect the negative (-) cable from battery and wait for at least three minutes.
Remove ignition key from the vehicle.
Disconnect the DAB, PAB, SAB and BPT connectors.
Remove the floor console. (Refer to BD group)
Disconnect the SRSCM harness connector (A) from the SRSCM (B).
Remove the SRSCM mounting bolts from the SRSCM, then remove the SRSCM.
Disconnect the negative (-) cable from battery and wait for at least three minutes.
Remove ignition key from the vehicle.
Install the SRSCM with the SRSCM mounting bolts.
Tightening Torque (SRSCM Mounting Bolt)
: 1.0 ~ 1.4 kgf.m (9.5 ~ 13.6 Nm, 7.0 ~ 10.0 lb.ft)
Connect the SRSCM harness connector.
Install the floor console. (Refer to BD group)
Connect the DAB, PAB, SAB and BPT connectors.
Reconnect the battery negative cable.
After installing the SRSCM, confirm proper system operation:
Turn the ignition switch ON; the SRS indicator light should blink for about six seconds and then go off.
